Structure: 40mm 10wall

Colours: Clear (g), pearlescent, specials*

Options: Double sided UV protection*, available in Marlon BioPlus

*Subject to minimum order quantities

(g) – glass effect

• Marlon Clickfix is a high quality, extruded, interlocking modular multiwall polycarbonate panel with a co-extruded UV resistant coating
• As polycarbonate is a thermoplastic, it is important to take thermal expansion and contraction into account during any installation process.
• Marlon Clickfix has been independently tested to various Fire Standards; for the most current certification please contact our Technical Department.
• Marlon Clickfix panels are REACH and RoSH compliant, and 100% recyclable
• Any colour option is a through-colour so the colour of a cut edge will match the colour of the surface.
• Marlon Clickfix panels are covered by a limited warranty.  For full details contact our Technical Department

• 70mm frame profile allowing façades up to 8m
• Two part glazing profile, registered design  
• Shared coextruded high temperature dynamic grey TPV gasket (Santoprene)
• Glazing panels sit into frame without rotation
• Fully water managed via hidden drainage channel
• Pre-formed 90˚ corners
• Same profile across all orientations

• 90mm frame profile for facades up to 12m
• Fully thermally broken
• Temperature stable TPE gaskets
• Fully water managed

As a condition of ensuring that Marlon Clickfix panels perform at optimum throughout their service life and retain light transmission properties, it is recommended that the panels be cleaned periodically using suitable household cleaning agents as follows:

• Use lukewarm water to rinse the panel and soften dirt.
• Make up a solution of lukewarm water and ordinary household cleaner or a mild soap and use this to wash the panel.
• A sponge or soft cloth should then be used to gently remove dirt and grime.
• The cleaning process should then be repeated and the panel rinsed and dried with a soft cloth.
  

WARNING

Care should be taken to observe the following precautions:

1. Do not scrub Marlon Clickfix panels with brushes or sharp instruments as they will mark easily.
2. Never steam clean, use low pressures for pressure washing.
3. Avoid any abrasives or cleaners of a highly alkaline composition.
4. It is generally advisable in all instances to test any cleaner on a sample piece of the Marlon Clickfix panel first and it should also be remembered that cleaners and solvents which state that they are suitable for cleaning polycarbonate may not be safe for use on the UV protective surface of the panels.